|
|
OPERATING INSTRUCTIONS
- Fill an ordinary foot bath basin with warm water (temperature between 30~38˚C) and with water level up to the ankle.
- Add a little salt to the water (best with refined salt).
- Plug the array into the output II socket of the device and place the array into the water.
- Wear the treatment pads on your shoulder or anywhere you like (refer to diagram below) and plug the other end into the output I socket on the device.
- Turn on the power supply, insert IC Card (card system) press start and set the time.
- Place both feet into the footbath basin and set the negative ions level (beginners - 1.6 to 1.8 Amperes). The timer will countdown from 30 minutes and the device will “beep” 4 times when the time is up, indicating end of the session. If you wish to continue using the device for somebody else, press the START switch again to begin operation.
- Remove the IC Card & switch it off after use and remove the plug from the power source.